en:e-602
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
— | en:e-602 [2018/10/31 18:10] (aktuell) – angelegt - Externe Bearbeitung 127.0.0.1 | ||
---|---|---|---|
Zeile 1: | Zeile 1: | ||
+ | ====== E-602 (E44) ====== | ||
+ | **Allwellenempfänger 44** (All Wave Receiver 44), **E44**; developed and produced by [[Autophon|Autophon AG, Solothurn]]. | ||
+ | As a successor to the [[E39]] receiver, which still used a technology with plug-in coil sets and a calibrated logging scale, [[Autophon]] started to develop a receiver with a turret tuner with directly switchable wavebands and a calibrated dial, which allowed the frequency to be read directly from the dial. | ||
+ | |||
+ | This receiver has been equipped with battery valves: it mainly used the battery heated pentode valve [[de:D1F]], which was available in sufficient numbers even during the later years in WWII. The receiver has been ordered from the KTA (Federal war technology department) in 1944, but the sets were available only in 1945. Until 1951, a number of 143 sets has been made at [[Autophon]] plant in Solothurn. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ===== Technical Data ===== | ||
+ | * [[Principle]]: | ||
+ | * [[Modes]]: [[A1]] with BFO, [[A3|AM (A3)]], [[A3J|SSB (A3J)]] with BFO | ||
+ | * [[Frequency range]]: 100 kHz - 37,5 MHz in eight frequency ranges, **turret tuner** for band selection | ||
+ | * **Analog dial**, nonlinear | ||
+ | * [[Sensitivity]]: | ||
+ | |||
+ | ==== Power Supply ==== | ||
+ | {{ : | ||
+ | * [[Mains]]: 110, 125, 145, 160, **220**, 250 V with matching power supply E44Z | ||
+ | * [[Accumulator / Batteries]]: | ||
+ | |||
+ | ==== Dimensions ==== | ||
+ | * Receiver case **E44**: 400 x 320 x 310 mm, 23.75 kg | ||
+ | * Mains power supply and audio amplifier **E44Z**: 400 x 200 x 310 mm, 18.8 kg | ||
+ | |||
+ | ==== Accessories ==== | ||
+ | * Standard antenna is a long wire antenna | ||
+ | * Antenna transformer **AT44** | ||
+ | |||
+ | ---- | ||
+ | |||
+ | {{: | ||
+ | ===== Operation ===== | ||
+ | The receiving equipment consists of the Receiver E44 in one case / container and the EZ44 in a second case, this one containing a separate mains power supply and an integrated audio stage (with a [[de: | ||
+ | |||
+ | Both sets are connected by a heavy multipole cable. The receiver itself has a weight of 23.75 kg and the power supply / AF amplifier case another 18.8 kg. Usually some 18 kg of accumulators came together with this set. | ||
+ | |||
+ | The front panel is divided in two sections by the horizontal linear dial of the turret tuning arrangement. | ||
+ | Above the dial, You find from the left hand the coaxial antenna connector and the sockets for connecting longwire antenna and earth, then the clock (many of these neat Swiss clocks have been taken away by station personnel when these receivers have been taken out of duty), and the signal strength meter. This can be switched to indicate the heaters and plate / B+ voltages. At the right upper corner, you find the socket for the multipole cable (caution: the receiver is almost useless without this cable) and some fuses. | ||
+ | |||
+ | Underneath the frequency dial, you find the rotary band switch operating the turret tuner - find the corresponding dial in the dial window - and at the right hand the main tuning knob with a mechanical blocking arrangement. | ||
+ | In a row of controls below, you find from the left the volume control (" | ||
+ | |||
+ | The single conversion set with two HF- and another two AF- amplifier stages is working with an intermediate frequency of 75 kHz in the ranges below 2 MHz and with an intermediate frequency of 1,6 MHz on the higher frequency bands. | ||
+ | |||
+ | A similar variant of this receiver, the [[E-603|E45]], | ||
+ | There have been only very few sets made of a VHF-variant [[E-604|E46]]. | ||
+ | |||
+ | ===== Technical Principle ===== | ||
+ | {{: | ||
+ | The antenna signal has to pass two RF preamplifier stages ([[de: | ||
+ | For [[CW]] and single sideband reception, the signal of the BFO ([[de: | ||
+ | |||
+ | ==== Valve setup ==== | ||
+ | The receiver itself uses only battery valves of the type [[de:D1F]], only the final audio amplifier stage in the power supply cabinet uses a [[de: | ||
+ | |||
+ | ==== Development ==== | ||
+ | |||
+ | ==== Field use ==== | ||
+ | In the years 1944/45, a total of 143 receivers have been built. | ||
+ | |||
+ | {{gallery>: | ||
+ | ===== Manuals ===== | ||
+ | * {{ : | ||
+ | * {{ : | ||
+ | * {{ : | ||
+ | ==== Additional information ==== | ||
+ | * [[http:// | ||
+ | * [[https:// | ||
+ | * [[http:// |
en/e-602.txt · Zuletzt geändert: 2018/10/31 18:10 von 127.0.0.1