Inhaltsverzeichnis
Hds-100
Hand punch Hds-100; manufactured by Siemens & Halske, Munich.
The Siemens hand punch Hds-100, which technically corresponds largely to the Stg-100 teleprinter, which is equipped with a built-in receiving punch and punched tape transmitter, was used in the command posts or writing offices to transfer prepared messages on punched tape. The set can be used as a fully-fledged teleprinter with the necessary accessories and cables.
Technical data
- Principle]]: Teleprinter (page teleprinter)
- Operation modes: CCITT No.2 / Baudot; 50 (75) Baud
Power supply
- Mains operation: 220 V AC mains, with the SG-67 mains power supply unit the set can be operated from different voltages from 110 - 250 V.
Dimensions
The Hds-100 hand punch fits into a voluminous crate:
- Crate A: Transport case: 617 x 682 x 762 mm; 83 kg
- Hand punch Siemens Hds-100 with support frame: 33 kg
- Mains power supply SG 67, inserted into case A on a sliding board
Accessories
- Mains power supply SG 67: for power supply from the mains, isolating transformer, input voltage switchable from 110 - 250 V, the pointer of the measuring instrument must be at the green mark for 220 V.
System material
The hand punch Siemens & Halske Hds-100 is a set almost identical to the Stg-100 teleprinter, which can process signals according to CCITT No.2. / Baudot Code 50 Baud. The teleprinter is equipped with an attached punched tape transmitter (right) and tape puncher (left) and has an automatic name transmitter. With the appropriate cable set and accessories, it can be used as a fully-fledged teleprinter in the same way as the Stg-100.
Power is supplied via the SG 67 power supply unit from the 220 V AC mains.
Technical principle
Tube assembly
Development
Use
Technical documentation
Further information
- The Telecommunications Equipment of the Swiss Armed Forces, Volume 14, The Terminals, Merker Verlag, Lucerne